Hello Guest it is March 28, 2024, 12:26:56 PM

Author Topic: RnR R08 ECO MOTION 2.0 + Spindle Motor - Connection  (Read 1355 times)

0 Members and 1 Guest are viewing this topic.

RnR R08 ECO MOTION 2.0 + Spindle Motor - Connection
« on: August 26, 2020, 12:02:15 PM »
Hi guys good morning!
I need a help to make the connection and activation on the correct pins.
I connected to the tutorial below, also using the third source with 10v. But I don't know how to connect the OUT outputs to trigger the spindle.

Thanks for the opportunity.

Offline reuelt

*
  •  520 520
    • View Profile
Re: RnR R08 ECO MOTION 2.0 + Spindle Motor - Connection
« Reply #1 on: September 12, 2020, 06:54:20 PM »
Hi guys good morning!
I need a help to make the connection and activation on the correct pins.
I connected to the tutorial below, also using the third source with 10v. But I don't know how to connect the OUT outputs to trigger the spindle.

Thanks for the opportunity.
Your RnR USB ECO Motion board does not have any relay.
Either replace with another controller board that has a relay or add a $5 5V relay (designed for Arduino) to convert one of the outputs to a switch.

(see attached)

The relay can then switch on/off your spindle controller.
« Last Edit: September 12, 2020, 06:56:59 PM by reuelt »
"the gift of God is eternal life through Jesus Christ our Lord"