Hello Guest it is April 24, 2024, 09:38:32 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Motion Controller  (Read 1036 times)

0 Members and 1 Guest are viewing this topic.

Offline bobbya47

*
  • 93 93
    • View Profile
Motion Controller
« on: September 18, 2020, 12:25:44 PM »
I know there is been some discussion on the UC300 controller but I am having problems getting the motors to run on mach3. The inputs are all working properly so I know communication is working. I believe that I do not have the ports and pins configued properly. I set them like the manual showed. I am using xp. Can anyone tell me which port and pins I should be using? Any help would be appreciated. This is the usb controller.
Logged

Offline TPS

*
  • 2,505 2,505
    • View Profile
Re: Motion Controller
« Reply #1 on: September 24, 2020, 02:42:16 PM »
btw in this Picture you can see, that they are using a Mach3 cracked licence.
we will not Support pirate licences.

@Tweakie, PLS lock this thread.
Thank You
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
Pages: 1   Go Up
« previous next »