I have a Denford Mill that is current running the dos based artisan CNC. It is PC Based and runs with a DB37 pin connection to the PC (connected to an ISA ard in the PC) thre is also a DB25 cable going to the PC's printer port.

I am assuming that the db37 is a fast connection to  control the servo's etc.

Has anyone got experience of this system??? I am hoping I can simply replace the ISA  and lpt1 with a bob (MB3) and control the servo's etc with that. Hopefully I can even just interface directly to these cables and job done???

Any help/advice greatly appreciated

Thanks
Rim