Hello Guest it is March 28, 2024, 07:52:16 AM

Author Topic: mach 3 turn tool table  (Read 617 times)

0 Members and 1 Guest are viewing this topic.

mach 3 turn tool table
« on: June 16, 2020, 03:13:51 AM »
sorry if im asking a stupid question ...

if i have the tool table populated  with t1 as a master tool.

say i profile some stock with t1 and its 40mm which is correct
i then use tool 3 to do another operation and make it 35.    when measured its 34
so can i without moving the x   just go into tool table make sure t3 is in the window  change part zero to 34  then hit touch x

so its a bit like populating the table by making and measuring test cuts with each tool rather than touching off

thanks