Third party software and hardware support forums. > Newfangled Solutions Mach3 Wizards
write wizard
(1/1)
trike2:
I can use the write wizard to engrave but when I save the .tap file and load it again, it put a bunch of circles in the cut. I am renaming the default "write.tap" file so I can find it again. It seams to be adding lines of code. I would like to not have to rewrite every time.
Tweakie.CNC:
To remove the 'crop circles' change the IJ Mode (Config. / General Config.).
(Ideally all Gcode files using arcs should contain the G90.1 / G91.1 as appropriate).
Tweakie.
Navigation
[0] Message Index
Go to full version