Hello Guest it is December 09, 2024, 05:12:36 PM

Author Topic: Breakout board choices with smooth stepper  (Read 26647 times)

0 Members and 1 Guest are viewing this topic.

Re: Breakout board choices with smooth stepper
« Reply #10 on: February 17, 2020, 07:40:17 AM »

No doubt the MB3 from CNCRoom or the Technics equivalent will be fine but they are approx. $180 or 200 Euro respectively.
Neither were available at the time I was building my machine but doubt I would have spent the extra even if they had been.

Craig

At the end we didn't go on with the development of a customized BOB, I would have liked that very much, but...... too much time needed for doing it...
We decided for the 3.4 BOB version from Technics and I already received 2 kits (BOBs + SST);
during this week I install it as well as the MACH4 hobby...