Hello Guest it is March 29, 2024, 09:36:23 AM

Author Topic: Mach3 and spindle not working.  (Read 832 times)

0 Members and 1 Guest are viewing this topic.

Mach3 and spindle not working.
« on: November 25, 2019, 10:49:54 PM »
Hello everyone.
I am using Windows 10 on the Computer.
I installed Mach3 for the Router, and also installed a USB wireless control card
to run the WHBO4B pendant.  I can control all of the Axis X, Y, Z, and A
but I cannot turn on the spindle. The computer recognizes the machine,
and all of the drivers are working properly.
I followed the Fuling Converter instructions for setting up the PWM and controls.
I am not 100% sure that I have Mach 3 configured properly because all of the information
I am finding addresses the serial port installation.
If anyone has advice on parameters/ setup and configuration I would greatly appreciate
your help and input.
Thank you
Don