Dear Support Team,

I have a NVUM V2 controller. I have moved the stepper motors for all the axis and i am getting 0-10 V DC for spindle speed also. I am at the final stage of my CNC built but stuck at spindle on/off. I have tried all the settings as per NVUM manual but still not working. Please help me to run the spindle from Mach3.


Regards,
Tejas Prajapati

Hi Tejas Prajapati,

Unfortunately Novusun is one of the businesses listed in our Hall of Shame for Mach3 Licence violation. As a result this forum does not support assistance with any of it's products unless you are a genuine Mach3 or Mach4 license holder.

This thread referrers; https://www.machsupport.com/forum/index.php?topic=24331.msg238650#msg238650

Tweakie.

(Please contact me by PM if you already have a genuine Mach license).