Third party software and hardware support forums. > PoKeys

Pokeys57cnc using 4 axis and want the #4th" axis

(1/1)

kentalstrup:
Hi
I have a setup as this.
Y- A, as slave to Y, X and Z
Now i want to have a 4Th axis, and use motor B, as driver for this, now that Pokeys57cnc have the possibility of controling 8 motors.
is this possible?
I do not want to disconnect any of the existing motors.
And naive as i am, thinking this would be a "semi" 5Th axis

Would Mach4 accept this?
Or is is a NO GO?
best regards.

Navigation

[0] Message Index