Hello Guest it is December 05, 2023, 12:00:17 AM

Author Topic: mach3 download and setup  (Read 847 times)

0 Members and 1 Guest are viewing this topic.

mach3 download and setup
« on: November 02, 2019, 08:43:29 AM »
I need some help with Mach3. I have a 1500 x1500 WorkBee with Nvum Mach3 controller.
1. Will it run on a laptop with Windows 10 and a 64 bit o/s processor?
    I have been told yes then no then yes then no and so forth.

2. When I load mach3 demo on my older Windows 7 32 bit laptop it seems to not show all the popups I have observed on tutorial videos posted on youtube.

3. After I have loaded the nvum software I can locate it, open it and extract it as instructed but I cannot get a successful transfer to the mach3 plugins. Yes, I have restarted my computer after changes made. No success.

I am not very computer literate. I have read and learned to make sure I am following instructions and have had no success. I have had a few on facebook attempt to assist with no success. I am at the point of major frustration and disappointment.
Is there any help? Can this be remotely resolved?

Offline Tweakie.CNC

  • *
  •  9,161 9,161
  • Super Kitty
    • View Profile
Re: mach3 download and setup
« Reply #1 on: November 02, 2019, 08:54:42 AM »
Hi DonYea,

Unfortunately Novusun is one of the businesses listed in our Hall of Shame for Mach3 Licence violation. As a result this forum does not support assistance with any of it's products unless you are a genuine Mach3 or Mach4 license holder.

This thread referrers; https://www.machsupport.com/forum/index.php?topic=24331.msg238650#msg238650


(Please contact me by PM if you have a genuine Mach license).
« Last Edit: November 02, 2019, 08:56:40 AM by Tweakie.CNC »