I need some help with Mach3. I have a 1500 x1500 WorkBee with Nvum Mach3 controller.
1. Will it run on a laptop with Windows 10 and a 64 bit o/s processor?
I have been told yes then no then yes then no and so forth.
2. When I load mach3 demo on my older Windows 7 32 bit laptop it seems to not show all the popups I have observed on tutorial videos posted on youtube.
3. After I have loaded the nvum software I can locate it, open it and extract it as instructed but I cannot get a successful transfer to the mach3 plugins. Yes, I have restarted my computer after changes made. No success.
I am not very computer literate. I have read and learned to make sure I am following instructions and have had no success. I have had a few on facebook attempt to assist with no success. I am at the point of major frustration and disappointment.
Is there any help? Can this be remotely resolved?