Unfortunately it does not seem to make  difference in which order the table or computer is turned off, I have checked we only have the single profile installed and even re-installed Mach4 today and still getting the same behaviour any ideas?

Thanks

Adam

i think bater ask the UC300-ETH  suport
when i had problems with pokeys i asked them i got very good service
so i think if they cant support you for such main problem ,maybe batter consider change hardware
its not expensive and if it save you head ace its worth the money i think(i not part of pokeys not get from them 1 dollar
but i get good service so i real like share this point with this forum)