Third party software and hardware support forums. > HiCON Motion Controller
Hicon board wiring to fire plasma torch
(1/1)
Route66Retro:
Hi, I'm building a plasma table. I'm using Mach4 with the Hicon Integra 7766 board. I have the stepper motors all working properly but I cant find any documentation on wiring the plasma torch. Any help is greatly appreciated!
Vital System Support:
Hello,
Have you gone through this document http://www.vitalsystem.com/portal/cnc/motion/ArcProPlasmaGuide.pdf which talks about wiring the THC-150 Proma and the HiCON 7766 controller for Plasma Torch Height control (Page 5).
You can visit our Knowledge-base page http://www.vitalsystem.com/portal/support.php under 'ArcPro Plasma' has some good information about the THC sequence and signals.
You can mail support@vitalsystem.com for any further questions regarding this topic.
Let us know if the above answers your question.
Route66Retro:
Thanks! I'll check those links
Navigation
[0] Message Index
Go to full version