Hello Guest it is October 05, 2024, 08:55:20 PM

Author Topic: Machining relief problems  (Read 5731 times)

0 Members and 1 Guest are viewing this topic.

Re: Machining relief problems
« Reply #20 on: September 13, 2019, 04:05:55 AM »

Found the problem, the cagey buggers swapped motor wires, black and blue, that's why the "A" axis was working but the others not and I had wired all according to the "A" axis.

A trap for "young" players I guess, all working now, will do a test cut later.

Cheers Chuck
Re: Machining relief problems
« Reply #21 on: September 16, 2019, 02:46:55 AM »
Hi guy's,

Carried out a test cut and all is good, thanks for everyone's advice, but it seems the problem was down to inferior stepper drivers.

Cheers Chuck