General CNC Chat > Show"N"Tell ( Your Machines)

Cnc Id od and thread grinder

(1/5) > >>

Mark B:
Well started on a project to build a small Id od grinder. Almost all the pieces are in and had a few set backs. I'm includingapic of some of the initial electronics.  I'll have some questions soon but wish me luck.

Tweakie.CNC:
Hi Mark,

I am looking forward to following your build project - all looks good so far  :)

Tweakie.

Mark B:
Just got the cross slide in last night.  Today I'm measuring and designing the adapter plates and mounts and figuring out heights for the main axis.  1 question I am planning on using a stepper for the spindle ( Low rpm)  and a y axis for the thread grinding. Is there a way to config mach that way. 1 time keep turning 2nd move proportionally to the z axis. ( the 2nd I can do with gcode easy enough).

Mark B:
100mm linear axis

Tweakie.CNC:

--- Quote ---1 question I am planning on using a stepper for the spindle ( Low rpm)  and a y axis for the thread grinding. Is there a way to config mach that way. 1 time keep turning 2nd move proportionally to the z axis. ( the 2nd I can do with gcode easy enough).
--- End quote ---

I am not sure I fully understand this ?

Tweakie.

Navigation

[0] Message Index

[#] Next page