Hello Guest it is March 28, 2024, 11:23:04 AM

Author Topic: Galil setup with Mach 3  (Read 5431 times)

0 Members and 1 Guest are viewing this topic.

Galil setup with Mach 3
« on: July 21, 2016, 04:11:10 PM »
I am new to Mach 3 and I am look for information on setting it up with a Galil board. Is there a how to or tutorial available? This is on an older large format routing table and we are wanting to upgrade the 16 year old software.
Re: Galil setup with Mach 3
« Reply #1 on: July 25, 2016, 10:56:05 AM »
I have managed to configure the XY & Z axis and they just need some minor tweaking for accuracy and maximum speed. I have not yet been successful in activating the spindle, vacuum table, or misters.
Re: Galil setup with Mach 3
« Reply #2 on: October 03, 2020, 10:54:41 PM »
My original request a bit over 4 years ago. Due to a lack of support I gutted the system and installed an ESS board and with at the time prototype Gecko Motion Control stepper boards. I left this company over a bit over a year ago, but the system was fully 3D functional.