On my newly setup cnc my axes are moving fine, however for X axis my digital readout in Mach3 is showing negative values when my spindle is moving from left to right. meaning my 0 is at the most left edge of the table and instead of going to positive it goes into negative X direction and readings are negative.
My Controller is Stb5100, Motor Driver Tb6600. using laptop/usb..
I tried all combinations of different limit switch locations on LH/RH, Close/Far end along with changing Homing Directions to support that. I just cannot get a normal coordinate system: X axis to go to X+ when moving to the RHS, Y axis to go to Y+ going away from me and Z axis to go from Highest Position Zero towards Z- when going negative.
Many thanks in advance!