The machine has worked for years.
Power supply failed so I had my friend (owner of the machine a few years now) replace the power supply and it worked fine then he got his own license and when he installed the latest software using his license the motors will lock up but will not move.
He has been in contact with mach support and has spent many hours with them as well as me (I am 250 miles from him) and we still can't get the motors to move.
The limit switches respond in the diag page so at least part of the system is working.
Here is a look at what was used when the machine was built:
http://www.seabreezeparachutes.com/7x13cncproject/casebuild/view.htmlThe power supply was changed and the machine did run after the change and it still locks up now when the power is turned ON. But there is no motor movement when the DROs move.
Running win XP
32 bit
printer port
Followed and repeated basic setup many times from many videos.
But again no movement from the motors but they do lock up when power is turned on.
Any idea what we are missing?
Thanks in advance!