Hello Guest it is March 29, 2024, 07:38:21 AM

Author Topic: Help in settings...  (Read 2663 times)

0 Members and 1 Guest are viewing this topic.

Help in settings...
« on: August 28, 2007, 07:32:06 AM »
I need some help in the seetings of mach3.
While the motors are moving, i can hear a noise like "gap-gap..." given in stable time.
I suppose that the problem is the PC, because i have used another PC and i didn't have these problems.
I have changed the configurations to this PC as www.machsupport.com gives (msconfig, etc...).
Has the kernel speed to do with that? What should i look for?
Any advice would be helpfull.
Re: Help in settings...
« Reply #1 on: September 04, 2007, 08:24:00 AM »
Hello, Have a look on the downloads page and you will find the optimization guide, in this will will find all the steps needed to get your steps a bit smother..
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com