General CNC Chat > Show"N"Tell ( What you have made with your CNC machine.)
Giant Sparkplug
(1/1)
stevehuck:
Thought you guys might get a kick out of this. Its a Champion 3X spark plug four time scale. Most of the parts were CNC'd about 50-75%. There is a battery pack in the top insulator that can be charged through a USB socket. The base houses a 400,000 volt module that can easily jump a one inch gap. I set the gap at 3/4 inch.
I made it as advertisment because I sell miniature spark plugs. Hoping it will draw attention to the business at the model engineering shows.
https://www.youtube.com/watch?v=69DJEpu_64A
joeaverage:
Hi,
kool....can I order a waterproof one to put in the mother-in-laws bath? ;D
Craig
N4NV:
Awesome project! Where did you get the 400,000V module?
Vince
stevehuck:
--- Quote from: N4NV on March 31, 2019, 09:08:18 AM ---Awesome project! Where did you get the 400,000V module?
Vince
--- End quote ---
Hello Vince
The module can be had on ebay for 2 or 3 bucks. They are pretty bad. They burn out awefully fast. I will never use them in another project.
Navigation
[0] Message Index
Go to full version