Hey all,
I'm using a rotary table to do some parts by turning 60 degrees at a time and milling a small hole at each stop.
Problem is when I'm done with the part I've been commanding the rotary to go back to 0 so for each part I'm making two turns of the rotary table.
I'm thinking there has got to be a better way.
Can I reset the DRO or something to keep from having to turn all the way back to 0 each time?

Thanks

James

I'm not sure Mach3 supports this but on most controls you can enter 'G92 A0' into the code and it will zero out the A axis.

Graham.

That will work

Worked like a charm!!

My rotary table and I thank you 

James

One more question.
Is there any way to have a bell or sound activated say when a tool change or end of program?

I've looked over G and M codes and don't see anything.

Thanks

Yes you can write an Mcode that will play a wav file or you can use the speak... IF you need a hand with the macro I can help you out.