Hello
Guest
it is
May 01, 2025, 01:43:41 PM
Guest
Login
Register
Menu
Home
Help
Search
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Where am I?
« previous
next »
Print
Pages:
1
Go Down
Author
Topic: Where am I? (Read 2860 times)
0 Members and 1 Guest are viewing this topic.
Cheska
6
Where am I?
«
on:
March 11, 2019, 08:17:15 AM »
Through Manual travel all limit switches set fine. home is front left corner fine. when i travel from home into cutting are all dros read negative numbers how do I reverse the polarity of these, making them positive and know where to cut?
Logged
MN300
306
Re: Where am I?
«
Reply #1 on:
March 11, 2019, 09:17:54 AM »
Interchanging the leads of one of the stepper motor windings will reverse the motion. However you then will need redefine the IO configuration to swap the limit switches and invert the home switch input polarity. (Assuming they are working correctly now) Don't forget to mark the changes on your wiring diagram.
Logged
Cheska
6
Re: Where am I?
«
Reply #2 on:
March 12, 2019, 07:59:33 AM »
That worked thanks
Logged
Print
Pages:
1
Go Up
« previous
next »