Hello Guest it is September 30, 2023, 09:50:42 AM

Author Topic: Modified pocket wizard?  (Read 2375 times)

0 Members and 1 Guest are viewing this topic.

Offline Keith

  • *
  •  187 187
    • View Profile
Modified pocket wizard?
« on: March 28, 2006, 11:24:46 AM »
I've fooling around a lot with the wizards lately and I was wondering if there was a way to use the 'circular pocketing' one to modify the portion of a radius involved in the cutting.Picture a 2" hole already cut out(no material) and at the edge of this cut out,I'd like to pocket a concentric (negative)lip around the circumference of the 2" cut out.So I would begin or end at the center of the circle.Just a pocket of a portion of the circle.I know the other ways to do this but in this case a spiraling pocket would be sweet.Thoughts?(yeah I could write the code for this but I'm digging these wizards)-Keith
Re: Modified pocket wizard?
« Reply #1 on: March 28, 2006, 03:50:49 PM »
I am in hopes to have Lcam doing all that stuff :)
Fixing problems one post at a time ;)