Good morning Brain, and all others.
I took some time to go through everything again to see if I could figure this out, still having problems. First let me say x, y, z axis all work fine.
Now Brain using what you had above, I went to Output Signals and changed output # 1 to enabled , port 1 and pin 1, then to spindle setup and changed output for cw and ccw to # 1. On the Xylotex board there is a pin labled P1, hooked the SS relay to that pin, OK so far so good, my relay kicks in and turns on the spindle. Have not tried it with software yet just using the Diagnostic page to test it.
OK now the next step I am having problems with, I can not seem to understand how to get mist up and working also. Xylotex has number of pins along with the P1,,so if I was to use P14, could you tell me the set up. Now I double checked to make sure the SS relay was working, so it has to be me not getting things right, and have tried different setups in Mach to try.
Thanks for your help,
Jim
Abbotsford, BC