Hello Guest it is April 24, 2024, 08:22:50 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Spindle runs on button double click but stops on M3  (Read 3991 times)

0 Members and 1 Guest are viewing this topic.

Offline ZASto

*
  • 423 423
    • View Profile
Re: Spindle runs on button double click but stops on M3
« Reply #10 on: January 23, 2019, 05:25:19 PM »
You didnt have to modify the macro to wait for spindle to accelerate.
You can adjust the wait time in: Config/Ports & Pins/Spindle setup tab. There are CW Delay Spin UP, CCW Delay Spin Up ... parameters.
Kep your M3 macro simple.
Logged
Make no mistake between my personality and my attitude.
My personality is who I am.
My attitude depends on who you are.
Pages: « 1 2   Go Up
« previous next »