Hello Guest it is March 28, 2024, 11:34:08 AM

Author Topic: MPG convert rotary pulse generator to lever actuation  (Read 1052 times)

0 Members and 1 Guest are viewing this topic.

MPG convert rotary pulse generator to lever actuation
« on: January 10, 2019, 04:01:56 PM »
I am looking for someone to collaborate with me on developing a way to use the z axis with a traditional lever (drill press type) switch over from the mpg.  Someone who has experience with the mpg and Mach3 would be needed.  Contact via email to discuss further
nelsonk11@hotmail.com
Re: MPG convert rotary pulse generator to lever actuation
« Reply #1 on: January 11, 2019, 05:50:47 AM »
Sounds to me like you just need to set the spindle lever up as your Z axis. pop a stepper and a belt drive on it and configure Mach3 to run with the MPG you have, and you should be good. With this said I think you'd be better off programming a drilling cycle for what you need doing, it will be more consistent, quicker and safer.

Offline RICH

*
  • *
  •  7,427 7,427
    • View Profile
Re: MPG convert rotary pulse generator to lever actuation
« Reply #2 on: January 11, 2019, 06:27:02 AM »
I suggest you consider something different. There is too much backlash in the rack and pinion.
Not an answer to your question, but been there done that and similar.

RICH