Mach Discussion > FAQs
touch plate guru brew plan- not getting mx4660 to cooperate
firewoods:
sorry- we were running out the door, and I thought I did post the diagram...
firewoods:
--- Quote from: TPS on January 10, 2019, 02:48:40 AM ---ok had a look to the leadshine Manual.
you have to make a Bridge from the +12V out terminal to the OPTO2 teminal
and then you can use GND and Input3/4.
--- End quote ---
this makes sense, I think- thank you!
firewoods:
TPS-
It's working! I owe you a beer, my friend...
Best!
Navigation
[0] Message Index
[*] Previous page
Go to full version