Hello Guest it is November 15, 2019, 01:19:37 PM

Author Topic: mach3 mill program simulator  (Read 285 times)

0 Members and 1 Guest are viewing this topic.

mach3 mill program simulator
« on: December 19, 2018, 04:38:11 PM »
I have a need to know how long any program will run. The program simulator under the tool path tab only runs part of the program. Is there a way to convince the simulator to include the entire program?

Offline ZASto

*
  •  185 185
    • View Profile
Re: mach3 mill program simulator
« Reply #1 on: December 19, 2018, 05:10:44 PM »
Unlicensed version will process only 500 lines of code.
Make no mistake between my personality and my attitude.
My personality is who I am.
My attitude depends on who you are.
Re: mach3 mill program simulator
« Reply #2 on: December 19, 2018, 05:25:01 PM »
I have a licensed version
Re: mach3 mill program simulator
« Reply #3 on: January 04, 2019, 12:28:36 AM »
I think the timer may reset when you encounter a tool change. Try running a temporary file using only one tool if you can. Or break the program up into 3 separate programs, one for each of 3 tools (or however many tools you need).