Author Topic: Driver Question mark  (Read 282 times)

0 Members and 1 Guest are viewing this topic.

Offline tiggabean

  • Active Member
  • Posts: 4
    • View Profile
Driver Question mark
« on: December 07, 2018, 12:22:26 AM »
Hi All

I'm a newbie, trying to setup a cnc.

I have a Hp with Win7 32bit with a pci parallel port.

Every time I try to install Mach 3 I get a blue question mark displayed on the driver.
Driver test gives excellent results, but I cannot get anything moving on the cnc.

Any bright ideas to fix this?

Offline TPS

  • Active Member
  • Posts: 1,121
    • View Profile
Re: Driver Question mark
« Reply #1 on: December 08, 2018, 05:22:03 AM »
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline tiggabean

  • Active Member
  • Posts: 4
    • View Profile
Re: Driver Question mark
« Reply #2 on: December 10, 2018, 02:04:11 AM »
Thank you for the reference,
 but will this assist with the driver?

Offline TPS

  • Active Member
  • Posts: 1,121
    • View Profile
Re: Driver Question mark
« Reply #3 on: December 10, 2018, 10:43:47 AM »
i realy dont know, but you can give it atry.
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.