Hello Guest it is June 02, 2023, 10:56:10 AM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Question around operation and parameters  (Read 5996 times)

0 Members and 1 Guest are viewing this topic.

Offline jimpinder

*
  • 1,232 1,232
  • Wakefield, West Yorks, UK
    • View Profile
Re: Question around operation and parameters
« Reply #10 on: March 04, 2008, 02:30:20 PM »
My list shows that  "SetCurrentTool"(Tool  as byte) is a subroutine, not a function.

Logged
Not me driving the engine - I'm better looking.

Offline tom_emag

*
  • 11 11
    • View Profile
Re: Question around operation and parameters
« Reply #11 on: March 05, 2008, 10:01:55 AM »
Got it...  I changed the lines to "call SetCurrentTool(x)" and it's working fine.

Can you tell me where I can get the "list" of calls and functions?  I looked all over the MachCustomizeWiki and did not see it?
   Thanks for the help.
Logged

Offline jimpinder

*
  • 1,232 1,232
  • Wakefield, West Yorks, UK
    • View Profile
Re: Question around operation and parameters
« Reply #12 on: March 05, 2008, 01:23:09 PM »
I think it is a Wiki attached to this forum -
it is at
« Last Edit: March 05, 2008, 01:26:15 PM by jimpinder »
Logged
Not me driving the engine - I'm better looking.
Pages: « 1 2   Go Up
« previous next »