Hello Guest it is November 21, 2019, 09:20:04 PM

Author Topic: Setting Mach 3 Port to PCI parallel port address  (Read 111559 times)

0 Members and 2 Guests are viewing this topic.

Re: Setting Mach 3 Port to PCI parallel port address
« Reply #60 on: November 21, 2018, 07:38:33 PM »
I’m not shame to admit Craig, that clearly describe me at this point

Offline TPS

*
  •  1,407 1,407
    • View Profile
Re: Setting Mach 3 Port to PCI parallel port address
« Reply #61 on: November 22, 2018, 01:30:53 AM »
attached a principal sheme for a Hardware circuit to do the squaring via relay/optocoupler.



@Craig
i absolutly aggre with you according XHC
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: Setting Mach 3 Port to PCI parallel port address
« Reply #62 on: November 22, 2018, 05:46:17 AM »
I would have to do something like that if everything else fails...
I heard back from XHC, they told me to tick off A-axis in ports and pins
Re: Setting Mach 3 Port to PCI parallel port address
« Reply #63 on: December 02, 2018, 09:41:28 PM »
Well, just a quick update... it’s been over a week now since I last heard from HXC, they asked for some setup information, I sent it but no reply yet, I may just ask for money back and get something different...I will update again soon...