Tangent Corner > Bargain Basement
Gecko G320X/G320
thosj:
I have 7 Gecko G320X Servo drives for sale.
I have 5 Gecko G320 Servo drives for sale.
All in great shape, all working when removed. None used a lot but all probably over 7 years old.
G320Xs $50 each shipped to US addresses only.
G320s $30 each shipped to US addresses only.
Shipping from Greenville, WI, USA, PayPal OK or ??
C Hammerle:
Hi there; By chance, are these still available (320x)
Clint
thosj:
They are, actually!! I'd have to go look again in the shop, but I don't remember getting rid of any!!
What do you need?
C Hammerle:
Hello again, By chance did you find the drives? I'd like to offer you 300$ for all 7 320x drives.
And while I'm at it....how are your diagnostic skills? I have a dead DIY cnc and haven't found out why yet. I seem to have voltage where there should be. However, trying to trace backwards on my rs-232, I found that I ahve resistance when crossing probes from step and direction points. One lead of the meter on the drive and the other on the breakout board. The step and direction are seemingly correct to common.
How does one trouble shout these breakout boards?
From the DB 25 connector, I get no resistance readings to the drives.
Thank you for your time.
Clint
thosj:
Ah, man, I looked, there were 7, and I forgot to come back here and tell you. So I'll accept $300 for the 7 G320x drives.
We should probably take this off of here. Text nine two zero two five seven seven seven zero six (hopefully you have a cell phone!!) and we'll work it out. PayPal preferred, and I'll pay shipping long as you're not in Timbuktu!!
I don't have an answer to your troubleshooting question. Maybe try the breakout board manufacturer unless it's one of those totally generic simple break-out-the-pins boards. If it's a PMDX or CNC4PC you should be able to get some help.
Tom
Navigation
[0] Message Index
[#] Next page
Go to full version