Mach Discussion > Brains Development
CNC Router VFD spindle help.
gbilya1028:
I am using Mach 3 with a Benchtop Pro CNC Router. I am wondering if there is any way I can have Mach 3 execute following commands while spooling up the spindle to 22000RPM. I am loosing 8 seconds in cycle time since the program waits for the spindle to get up to 22k RPM before it moves to next line. Any help is much appreciated!
gbilya1028:
Here is a link to the spindle if it helps.
http://www.cncrouterparts.com/22-kw-plug-and-play-spindle-vfd-system-p-353.html
ger21:
Config >Ports and Pins > Spindle tab. There are settings for delays there.
gbilya1028:
I am new to Mach 3 so would you mind explaining in detail?
ger21:
What are your settings on this screen?
Navigation
[0] Message Index
[#] Next page
Go to full version