Hello Guest it is March 29, 2024, 04:55:39 AM

Author Topic: LIMIT I/O how ?  (Read 3564 times)

0 Members and 1 Guest are viewing this topic.

Offline cnc-project

*
  •  9 9
  • moja mala beba
    • View Profile
    • www.cnc-project.com
LIMIT I/O how ?
« on: March 27, 2006, 03:22:39 AM »
Im controled before on turboCNC , and now can problem how diseble  drives (pin 16) and configure LIMIT SWITCH   ...8 END LIMIT on axis, and 8 for manual like offset on stock  etc...

can some explain me  how can do  that ?

have 5VDC  (LM7805) optocooupler 16 ch, and 12VDC for relay ...
potencial of ZERO not problem, only  port-pin configuration...

is P3 933 Mhz , enuagh for MACH 3 on 25kHz ?

« Last Edit: March 27, 2006, 03:40:19 AM by cnc-project »
Re: LIMIT I/O how ?
« Reply #1 on: March 27, 2006, 06:59:24 AM »
Ther are outputs called Enable1-6. The output of this is to turn on and off your Drives. Have you had a look at the video's on how to test up mach? There is a good one on setting up the limit switches. 
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com