Hello, I'm hoping to use Mach3 to operate my diy 80W laser cutter engraver. I've purchase the AKZ250 Motion Control board and am looking for any experiences running a laser cutter with this board and Mach3. I would like some help with how to set up Mach3 to run a laser cutter. Is PWM the preferred way to go with an 80W laser cutter running Mach3 and an AKZ250? Are there any detailed procedures out there re laser operation with an AKZ250 and Mach3?
Any help and experiences with this approach would be greatly appreciated!
Thanks in advance.
Keith