Hello Guest it is May 23, 2019, 03:39:14 PM

Author Topic: DRO question  (Read 188 times)

0 Members and 1 Guest are viewing this topic.

Offline NormB

*
  •  169 169
  • Norm
    • View Profile
DRO question
« on: October 01, 2018, 09:23:53 AM »
Finally almost finished with configuration but something is strange not sure why.  When I auto zero Z the DRO registers correctly 2" where I set it to be after zeroing but when I look at machine coordinates I see a crazy number like .485 I am not sure why it is not agreeing with my work coordinates.  Any help is greatly appreciated.  <a href="http://" target="_blank" class="new_win">http://</a>

Offline TPS

*
  •  1,253 1,253
    • View Profile
Re: DRO question
« Reply #1 on: October 01, 2018, 01:41:56 PM »
i think you have to read a Little bit about machine coordinates and work coordinates.

machine coordinates will only be set to Zero by doing a reference with reference Switches.
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.