Hi,
Is there a setting in Mach4 that could pause the cycle after a certain time from the start of the cycle, I have build a plasma table and in the plasma cutters specs there is a 40% duty cycle per 10min, at around 5-6mins the thermal relay on the transformer trips and the torch turns off, so I would like to pause the cycle at the 5min mark. I know it would be possible to add a pause in the g-code but the feedrates change depending on the thickness of the plates cut so that isn't a viable option. Also the cutter is old enough that there are no output signals to use as a trigger of a pause, but if there is no time option in Mach4 I could wire a signal output using the thermal trip LED the cutter has.
Thanks
Oscar