Hello Guest it is January 26, 2020, 03:05:13 PM

Author Topic: CO2 Laser Mirror Allignment.  (Read 1077 times)

0 Members and 1 Guest are viewing this topic.

Offline Tweakie.CNC

  • *
  •  8,107 8,107
  • Super Kitty
    • View Profile
    • Tweakie.CNC
CO2 Laser Mirror Allignment.
« on: October 19, 2018, 07:58:28 AM »
Mirror adjustment / alignment for a CO2 laser is quite a tricky process. It usually involves placing a paper or tape target over successive mirrors and adjusting the previous mirror to centre the beam on the target – it is basically a trial and error process whilst test firing the laser.
This photo, of a slight mishap during a test fire, was posted on another forum and the owner of the finger commented: “it hurt, in fact it hurt quite a lot”.

Don’t we just have to be so careful when operating any of our CNC controlled equipment ?   :)

« Last Edit: October 19, 2018, 08:02:08 AM by Tweakie.CNC »
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.