Hello Guest it is September 19, 2020, 06:55:52 PM

Author Topic: Cannot probe in inverse time feed mode error  (Read 542 times)

0 Members and 1 Guest are viewing this topic.

Cannot probe in inverse time feed mode error
« on: September 10, 2018, 06:55:21 PM »
Mach 3 is set up and running with a Galil controller and servo motors. I can jog all three axes. However when I enter a G-code command G31 X-1 F30 I get this error and no motion. "Cannot probe in inverse time feed mode error". Any clue what that means I have done, or need to do? Everything works fine in Galil SmartTerminal.
Re: Cannot probe in inverse time feed mode error
« Reply #1 on: September 10, 2018, 07:29:20 PM »
Never mind! I should have entered G1, not G31.