General CNC Chat > Show"N"Tell ( What you have made with your CNC machine.)
Milldred gets some
Chris.Botha:
Thanks, the casts came up ok.
Chris.Botha:
Some help from you smart types... I had this same config a few years back, and it was silky smooth, but when i run code now its jerky..
the path that is running is doing a series of XYZA, followed by a B, then repeat.
If I manually jog the machine pressing XYZAB its fast and smooth even at 1200mm rapid.
Mach3
UC300 motion controller @ 100khz
Mach set to 100KHZ
Look Ahead on 1000 or even 2000 makes no difference.
Constant velocity is set on.
any tips?
https://www.youtube.com/watch?v=5W9KAiYdED0
Chris.Botha:
(i changed CV stop angle to 180 which dramatically improved things, can achieve 2000mm/min smoothly, what does changing that achieve? does it reduce accuracy somehow?
Navigation
[0] Message Index
[*] Previous page
Go to full version