Hello All,

I am trying to set up a trial version of Mach 3 to work with a 3rd party break out board.  The instructions that came with the board refer to going into 'Config/State'.  I have been unable to find that in the Config menu.  Am I looking in the wrong place, or do I need to buy the full version to get access to that area?  I plan to buy soon, but have to recuperate a little from the cost of the mill.  Any help is greatly appreciated.  Thanks!!

Ian

Which version are you running? I think that was for the older Ver 1.84. The menu's have been changed on the newer versions.

William

There used to be two pages, one called config state and the other I think config logic. They have now been combined into one page called general config. You can get to  it from the Config tab.
Hood