I have a G100 that I'm trying to use the 2.01 g100 plugin with. I've uploaded the firmware and the FPGA files that come with the plugin, but it's not working.
If I start mach3, it repeatedly says 'Found G100', initializing, Found G100, initialing, etc etc etc.
If I just leave it, the G100 starts up with the run LED red. Then after 10 seconds (autoboot timeout), the run LED goes out for about 1 second, following with it comes back on again as red. Rinse, repeat.
When it comes on again red, it's the boot loader running (I can connect to it with a browser).
It looks like the G100 is starting the firmware, running for about 1 second, crashing and restarting the boot loader?
The bootloader says:
Firmware size (bytes): 190806
Core: RCM3720/RCM3750
So it sure looks like it has the right firmware? I've tried re-uploading the firmware without any change in behaviour.
If I click 'test' in the FPGA section I get:
May 26 21:35:38 [1]: Download manager started
May 26 21:35:41 [2]: ifconfig: ipaddr=C0A80160/FFFFFF00 dhcp=no
May 26 21:35:41 [3]: Starting network...
May 26 21:35:42 [4]: IF_ETH0 is down
May 26 21:35:45 [5]: CRC_OK -- yes
May 26 21:35:45 [6]: Auto boot DLP in 10 sec
May 26 21:35:51 [7]: Ethernet interface is up at 192.168.1.96
May 26 21:35:52 [8]: Auto boot postponed, HTTP used
May 26 21:38:06 [9]: Loading FPGA config 1...
May 26 21:38:07 [10]: XSVF loader completed
May 26 21:38:07 [11]: Programming time = 1046ms
May 26 21:38:07 [12]: Config completed
May 26 21:38:07 [13]: FPGA version register (addr 0x01) reads 0x08
May 26 21:38:07 [14]: FPGA vers.release = 0.8
May 26 21:38:07 [15]: FPGA status register (addr 0x00) reads 0x94
Which looks pretty right to me?
Any ideas??