Hello Guest it is September 26, 2020, 05:24:29 AM

Author Topic: Config/State only for licensed versions??  (Read 2194 times)

0 Members and 1 Guest are viewing this topic.

Config/State only for licensed versions??
« on: July 25, 2007, 04:38:27 PM »
Hello All,

I am trying to set up a trial version of Mach 3 to work with a 3rd party break out board.  The instructions that came with the board refer to going into 'Config/State'.  I have been unable to find that in the Config menu.  Am I looking in the wrong place, or do I need to buy the full version to get access to that area?  I plan to buy soon, but have to recuperate a little from the cost of the mill.  Any help is greatly appreciated.  Thanks!!

Ian

Offline Whacko

*
  •  239 239
  • Happy Days
    • View Profile
Re: Config/State only for licensed versions??
« Reply #1 on: July 25, 2007, 06:04:35 PM »
Which version are you running? I think that was for the older Ver 1.84. The menu's have been changed on the newer versions.

William
Nothing's impossible

Hood

*
Re: Config/State only for licensed versions??
« Reply #2 on: July 28, 2007, 06:36:09 PM »
There used to be two pages, one called config state and the other I think config logic. They have now been combined into one page called general config. You can get to  it from the Config tab.
Hood