Hello Guest it is March 28, 2024, 05:33:21 AM

Author Topic: Radius to end of arc differs from-  (Read 2324 times)

0 Members and 1 Guest are viewing this topic.

Radius to end of arc differs from-
« on: July 19, 2018, 01:51:42 PM »
I have used my home built CNC router for some time now free of any major problems or errors. However yesterday I was running a project that I created in Fusion 360, and when I loaded the G-code into my Mach3 software. I received an error informing me that the Radius to end of arc differs from- not able to read the remainder.
After repeatedly running the G-code of a simple circle and coming up with the same error, I now ran the model and g-Code through Cam Bam and yet I received the very same error. Am I correct assuming that the problem is in Mach 3 and if so any ideas on how to repair the problem.
Thank You for any help anyone can provide.
Jim

Offline ger21

*
  • *
  •  6,295 6,295
    • View Profile
    • The CNC Woodworker
Re: Radius to end of arc differs from-
« Reply #1 on: July 19, 2018, 04:03:58 PM »
Check your IJ mode in General Config. In most cases, it should be set to incremental.
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Re: Radius to end of arc differs from-
« Reply #2 on: July 19, 2018, 04:46:18 PM »
ger21
Thank you very much for your help with my problem. You hit the nail on the proverbially head with your suggestion, all is well. By the way, I’m also a licensed user of your screen set which I use exclusively.
Gerry Thank you once again for your help
Jim