Hello Guest it is October 19, 2019, 06:45:16 PM

Author Topic: How to activate output a few seconds after Mach starts?  (Read 990 times)

0 Members and 1 Guest are viewing this topic.

How to activate output a few seconds after Mach starts?
« on: April 07, 2018, 11:52:39 AM »
How do I activate an output a few seconds after Mach starts, and then stay on for the duration of the session?  I prefer to use a brain, and know how to add the delay before driving the output, I just don't know what to use for the first box in the brain?

I don't want to waste and input.

Thanks,

Offline TPS

*
  •  1,389 1,389
    • View Profile
Re: How to activate output a few seconds after Mach starts?
« Reply #1 on: April 07, 2018, 01:59:02 PM »
use the Output itself

Output - pass through     |
Output - invert Signal      | OR   delay Output
« Last Edit: April 07, 2018, 02:03:55 PM by TPS »
anything is possible, just try it.
if you find some mistakes, in my bad bavarian english,they are yours.
Re: How to activate output a few seconds after Mach starts?
« Reply #2 on: April 07, 2018, 02:39:49 PM »
Thanks, I had no idea I could do that