Hello Guest it is April 16, 2024, 01:12:16 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Help with my THC control  (Read 2567 times)

0 Members and 1 Guest are viewing this topic.

Offline Budyman

*
  • 4 4
    • View Profile
Help with my THC control
« on: March 30, 2018, 03:55:44 PM »
I have proma THC 150 and mach3 is not recognizing my Z up. it sees Z down and THC on also torch on but not my Z up. Any ideas?
Logged

Offline Budyman

*
  • 4 4
    • View Profile
Help with my THC control
« Reply #1 on: March 30, 2018, 08:47:45 PM »
I got the proma THC controller to work in simulation mode but when I go to use it still runs into the metal any ideas
Logged

Offline TPS

*
  • 2,505 2,505
    • View Profile
Re: Help with my THC control
« Reply #2 on: March 31, 2018, 06:01:18 AM »
we hae worked through the same Thing here:

http://www.machsupport.com/forum/index.php/topic,36550.90.html
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.

Offline Budyman

*
  • 4 4
    • View Profile
Re: Help with my THC control
« Reply #3 on: March 31, 2018, 09:35:12 AM »
Thanks now my new issue is when you're getting ready to cut the torch starts its Pierce  then just starts going up and never comes back down I have to stop the process. It works in simulation mode torch on Z up Z down and so forth.
Logged

Offline Budyman

*
  • 4 4
    • View Profile
Re: Help with my THC control
« Reply #4 on: March 31, 2018, 11:59:52 AM »
Also I use sheetcam I was wondering what post processor I should use and I do not have a floating head any ideas
Logged
Pages: 1   Go Up
« previous next »