Hello Guest it is May 22, 2024, 07:03:30 PM

Author Topic: soft limit system movement aborted  (Read 1206 times)

0 Members and 1 Guest are viewing this topic.

soft limit system movement aborted
« on: November 25, 2018, 07:06:19 PM »
Mach 3 stopped mid cut and the only thing I noticed was the single Blk Alt N light was flashing (it could always have blinked and I never noticed it). I have full movement around the table just jogging it but when I load a file and try to run I get nothing . I tried several patterns I know that work Mach3 said it was jogging to starting point (which it didn't move) and then nothing. The message line said Softlimits System Movement Aborted. It had cut all but the last 2 inches of a busy pattern when it just stopped. Thanks for any ideas you can toss my way.