Third party software and hardware support forums. > PoKeys
Setting error inputs
fane:
How do I set that driver error to stop all motors.
I use Mach3 and Pokeys57CNC.
fane:
Hi All,
OK, it's now resolved.
I have defined an OEM 1003 (stop) button, now I stop all if I have an error on an engine.
I use Closed Loop Hybrid Servo Step Driver.
geonik:
--- Quote from: fane on March 20, 2018, 11:42:23 AM ---Hi All,
OK, it's now resolved.
I have defined an OEM 1003 (stop) button, now I stop all if I have an error on an engine.
I use Closed Loop Hybrid Servo Step Driver.
--- End quote ---
Greetings Fane.
Sorry for bringing this matter back up after this much time, but I would like to ask how you managed to connect the input OEM trigger#1 to the OEM 1003 button.
Looking forward to your response and thank you in advance.
geonik:
Finally I found a solution through the brains
fane:
that's what i did
Navigation
[0] Message Index
[#] Next page
Go to full version