Hello Guest it is July 12, 2025, 06:00:01 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: Quick question  (Read 3502 times)

0 Members and 1 Guest are viewing this topic.

Offline Kurt Rose

*
  • 5 5
Quick question
« on: March 03, 2018, 06:53:02 PM »
Can someone please refresh my memory and tell me how to delay axis movement to let my spindle get up to RPM before it enters the cut.
Logged

Offline joeaverage

*
  • 7,606 7,606
Re: Quick question
« Reply #1 on: March 03, 2018, 07:00:57 PM »
Hi,
delay:
G04 P*********x  *********x in seconds/milliseconds dependent on General Setup.

Craig
Logged
'I enjoy sex at 73.....I live at 71 so its not too far to walk.'

Offline Tweakie.CNC

*
  • *
  • 9,299 9,299
  • Super Kitty
Re: Quick question
« Reply #2 on: March 04, 2018, 01:43:20 AM »
You may also want to consider Config. / Ports & Pins / Spindle Setup - set Spin Up delay etc.

Tweakie.
Logged
PEACE

Offline Kurt Rose

*
  • 5 5
Re: Quick question
« Reply #3 on: March 04, 2018, 08:26:20 AM »
Thanks Tweakie, thats what i have been attempting but it makes no difference what value I put in the CW or CCW box. I  now have 20 in both boxes and it does the same thing as if I have 1. Could it be another setting somewhere?
Logged
Pages: 1   Go Up
« previous next »