Hello Guest it is November 20, 2019, 02:24:29 PM

Author Topic: need object scanned.  (Read 609 times)

0 Members and 1 Guest are viewing this topic.

need object scanned.
« on: March 01, 2018, 07:04:21 PM »
  Hi all. I am in need of an item scanned. And maybe also ran into a CAM. Its a small piece 1 inch round 4 inches long. Can anyone help ? ASAP if possible
  Thanks for looking   Don

Offline Tweakie.CNC

*
  • *
  •  8,006 8,006
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: need object scanned.
« Reply #1 on: March 02, 2018, 01:59:41 AM »
Khalid was providing a scanning service a while back, you could perhaps PM or email him with an enquiry http://www.machsupport.com/forum/index.php/topic,16015.0.html

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline ger21

*
  • *
  •  6,288 6,288
    • View Profile
    • The CNC Woodworker
Re: need object scanned.
« Reply #2 on: March 02, 2018, 06:30:26 AM »
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html